If you’re weighing up options for your own workshop, from portable units to fixed installations, it’s worth talking through the layout with a supplier who stocks a range of systems, such as Tec Products UK.
The abrasive material itself matters as much as the shape. Discs formulated for steel typically contain aluminium oxide, while stainless steel usually calls for an inox-rated disc that’s free from iron, sulphur and chlorine contaminants that could otherwise cause surface corrosion on the stainless. Aluminium and other soft, non-ferrous metals need their own dedicated abrasives too, since standard steel discs tend to clog quickly and produce a poor finish on softer materials.
Space and power supply are the other two practical constraints worth checking early. Confirming that a chosen machine will run comfortably from the electrical supply actually available in the workshop, and that there’s room to work safely around it with materials laid out, avoids the common mistake of buying a machine that then can’t be used the way it was intended.
The figure changes with output. Turn the amperage down and the duty cycle climbs, because the internal components are working less hard. This is why a welder can feel completely different in a busy production environment compared with occasional home workshop use: someone welding continuously through a shift needs a much higher duty cycle at their working amperage than someone doing short repair jobs a few times a week. It’s the kind of spec worth comparing properly across brands such as Kemppi and EWM, not just reading off the headline amperage figure.
For anyone starting out, talking through process, budget and set-up with people who deal with first-time buyers regularly is generally worth more than another hour of reading spec sheets, and that’s exactly the sort of conversation the advice line at MIG welders Tec Products UK is there for.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.
If you’re weighing up options for your own workshop, from portable units to fixed installations, it’s worth talking through the layout with a supplier who stocks a range of systems, such as arc welding machines.
